# ICPLD config file.
# All options are set to boring, though reasonable,
# default, which should work for most users. The most 
# vital post to change, is the ip field.
#
# Note that icpld can check two connections at once, one
# IPv4 connection, and one IPv6. One of the two optione
# 'ip' or 'ip6' has to be set for icpld to start. 
# If you wish to disable any of the two, just leave that
# option empty.  

 
# IPv4 address to send ICMP requests to. This field is required, unless you specify
# an ip on command line, by supplying the -ip argument. This variable may also take
# a host name

ip=192.168.0.1

# Fallback ip. This is the ip we will probe for confirmation
# if 'ip' isn't responding. Leave emtpy to disable double checking.

fbip=127.0.0.1

# Same as 'ip' but IPv6. Leave this empty unless you have
# a working IPv6 connection and/or configured icpld with
# --enable-ipv6

#ip6=

# Same as 'fbip' but for IPv6. Leave this empty unless you
# have a working IPv6 connection.

#fbip6=


# How often will we check for replies?

interval=8

# How often will we check for replies if the connection is down?
# Can be lower than interval, since it won't load the target system.

dinterval=5

# Normally 'ping' sends one packet per second, with this option 
# you can change that frequence. Note that this is how often packets
# should be sent once the pinging sequence has commenced, and NOT how
# long to wait between the pinging processes.
#
# Also note that only a superuser, such as root, can set this value to 
# lower than or equal to 0.2 seconds. 1.0 is however a reasonable figure.

pint=1.0

# Which file should contain the log for IPv4?

logFile=~/.icpld/log

# The log is copied and converted into HTML format. This option
# specifies where the HTML formatted log will be located.
# Leave empty to disable log duplicating. 

htmlFile=~/.icpld/icpld.html

# This is the log to which we will log failures on a
# IPv6 connection. Comment out to use the same logfile
# for both IPv4 and IPv6

#logFile6=

# Same as htmlFile, but for the IPv6 log

#htmlFile6=

# Should we fork into background? true or false

daemonize=true

# Should we generate a sound when the connection comes up?
# Sound is only generated if daemonize is false.

nobeep=true

# This is a system command which will be executed when the IPv4
# connection is broken. This setting is optional and can be
# used to alert you whenever the status of your connection(s)
# changes. For instance, you can cose to play a sound when 
# the connection comes back up after down time or whatever
# you wish.

cmd4dn=play /home/erik/sounds/grunt.wav

# Same as above, but for when the connection comes back up

cmd4up=play /home/erik/sounds/yipee.wav

# Same as cmd4dn but for the IPv6 connection

#cmd6dn=

# Same as cmd4up but for the IPv6 connection

#cmd6up=